I have read as many threads as I can and have not found my answer. I have a 2012 outlander 1000xt that I just purchased used. It was snorkeled when I got it and I wanted to make sure the vent lines were snorkeled as well. I found the coolant weeping hose and ran it up, the rear diff and gear box are vented to the air box through the same hose, also the crank case is vented to the airbox, and the radiator vent is ran up. What I cannot figure out is that the front diff is ran into the fuel vent line and circles the top of the fuel pump and connects back into itself, so essentially it is vented into the gas tank through a continuous hose. There is no open end to the hose I am certain, I have looked at every inch of it and I also pumped air into the hose to see if it built pressure in the gas tank and it did. Is this like this from the factory or has someone changed it? If they are going to share a vent hose shouldn’t it come to a T and then have one hose with an open end ran to the pod? Any help is greatly appreciated I am new to the site and can am as well.
2012 outlander 1000 VENT LINE HELP!!
I have read as many threads as I can and have not found my answer. I have a 2012 outlander 1000xt that I just purchased used. It was snorkeled when I got it and I wanted to make sure the vent lines were snorkeled as well. I found the coolant weeping hose and ran it up, the rear diff and gear box are vented to the air box through the same hose, also the crank case is vented to the airbox, and the radiator vent is ran up. What I cannot figure out is that the front diff is ran into the fuel vent line and circles the top of the fuel pump and connects back into itself, so essentially it is vented into the gas tank through a continuous hose. There is no open end to the hose I am certain, I have looked at every inch of it and I also pumped air into the hose to see if it built pressure in the gas tank and it did. Is this like this from the factory or has someone changed it? If they are going to share a vent hose shouldn’t it come to a T and then have one hose with an open end ran to the pod? Any help is greatly appreciated I am new to the site and can am as well.