2011 800 50 prevention question?

First of all, let me start by thanking everyone that has helped me so far. So much great info here. I bought this used 2011 rzr approximately 2 months ago and have been working on it since. I live in southern Ontario with no trails for miles around. So I do very little riding. A couple of times a year I go north to a family camp where we run some logging roads and paths to hidden lakes for fishing. That’s about the extent of my riding. However we are hrs from any town with parts, so I’m trying to get this rzr ready by next month. I’m looking for suggestions to issues that I should check before going north. The rzr appears stock and currently has 1100 miles on it.
As of today: I have changed all fluids and filters, checked clutches, blew them out because they were dirty, but they operate smoothly, replaced belt, sealed cover, replaced water pump seal and vented weep hole, changed most bushings, one wheel bearing, front lower ball joints, greased suspension, replaced and relocated fan circuit breaker, dielectric grease on all connections, new plugs, compression test 185psi per side, cleaned entire intake system and tmap sensor, cleaned grounds and connections.
I still have to set the toe, clean and grease inner tie rods, thinking of disconnecting front sway bar because of some of the rough trails I ride.
Is there anything I’m missing. What else should I check and what spares should I bring with me? Relays, fuses ect. Thanks again for all your help. Just don’t want to be left stranded because of something simple.