FINALLY got the wife’s Rancher AT motor back in. I actually put it in a couple weeks ago only to find out the shifter was bound up, had to pull it again, tear the whole motor back down, and free up the shift drum. Got it back together and it will at least shift between gears with a little working back and forth on the rear wheel.

Got everything hooked up and found a bad starter solenoid. Jumping the terminals turns it over but it won’t fire. Verfied fuel is on at petcock, fuel pump housing is getting gas. Fuel injection relay clicks when I turn the key on. If I shoot starter fluid up in the intake it will fire off for a couple seconds so I know it’s getting spark.

At this point I’m thinking fuel pump isn’t working. Normally on the EFI rigs I’ve heard a buzzing noise when you first turn on the key. I don’t hear anything when I turn the key on. Fuel and temp lights briefly light up when I turn the key on like they’re supposed to, but that’s it.

Before I remove the whole fuel pump assembly I’d like to make sure it’s getting power. Does the electrical plug on top simply feed 12V to the pump? If so I’ll check it with a voltmeter before I remove the pump housing.