I cleaned the carb and it fired right up, but that’s where it ends. It goes nowhere. The drive belt cover was off and found later. There is a slight drag on the belt but there is no engagment to speak of. I bought an online manual but they leave a lot out. I have owned quite a few 2 stroke quads setup for the sand dunes, and over 20 various street and dirt bikes (yes, I’m old), but this is my first look at a 4 stroke ATV 4X4, and something with a CVS system. Two things, one – I think it might be clutch related, and two – i think there are parts missing. I have enclosed a photo of what was visable on the left side. Can anyone tell me if there should be additional parts by the front of the drive belt? Also, is there a trick for breaking that nut loose on the front pulley? I have researched this assembly online but everyone shows it by component instead of showing how everything goes together, even the manual fails to show an A-B drawing.
Any help would be appreciated, I’m stuck here and don’t want to start by breaking things.