I removed the old and installed the new carburetor and bike starts up just fine. However, on the panel instead of showing "N" or "D" it shows "- -" that blinks 4 times and ‘esp’ flashes below it.
I read on some threads on here that the error code relates to the TPS on the actual carburetor and the OHMS need to be adjusted to the correct resistance. Once that is done, then you need to go through a start up sequence by running bile for 1 minute, turn ignition of then while holding the UP and DOWN arrows simultaneously turn key on, release buttons then press UP, DOWN, UP.
My question if anyone can assist is 1. Where is the TPS located on the new carburetor and what OHMS RANGE is spec for this specific bike so I know where to put the meter? I dont have a service manual. And 2. Once adjusted properly do I go through that sequence again?
Didnt realize changing out carburetor with brand new one was going to cause all of these additional steps in order to work right.
Any help would be greatly appreciated.
