2005 Foreman No spark problem

As I mentioned earlier my bike won’t start – no spark. So I got the Honda manual, the recommended peak voltage adapter on this site, new coil, new spark plug. I used the trouble shooting list on page 19-4. In the section No Peak voltage at coil primary I failed the following:
5. No voltage at the black/white wire of the ECM. (Looking at the harness side of the terminal, the top right hand terminal is Red/white, the next one is the black/white. Is this correct?) Where does this wire originate?

10. Faulty CKP sensor. I measured the peak voltage at the alternator side of connector 5P, between the blue/yellow and white terminals. No Voltage.

The only thing I did not check is the gear position switch wiring. Where is this switch? When I change gears, the display correctly displays the right gear ( N, 1, 2 etc.) Does that mean that the switch is good?
Any suggestions? Any chance that the peak voltage adapter/multimeter combo is incorrect? Any way to test the adapter independent of the bike? Seems like the whole bike is just dead.

Thanks

Sandor