im running a pro circuit stainless steel header and a big gunevo R series slip on im using a dno jet kit with stage one and 2 jets in it. the directions say to use the dyno jet needle on groove 4 for below 5000 feet (im at 451 feet) then it says to use the dyno jet main adapter dja001 and to use main jet dj118 with an after aftermarket exhaust below 3000 feet an to set the a/f mix scew 3 turns out this dose not work at all iv checked to make sure i did it right over and over iv adjusted the needle height and the a/f mix screw with any combination you can imagine nothing really works any one got any tips? my machine ran 100% perfect be for here a pic https://www.facebook.com/photo.php?f…6626465&type=1