Ok guys so I had another thread on this and I thought I’d start a fresh one. My brake light was stuck on and still is. I replaced the bulb and no difference. I removed the front cover under the high beam headlight and saw the connector with the orange/ two red wires (one with white strip) connected to the brake pressure switch. When I remove it the brakelight goes dim to how it’s supposed to be when you’re not hitting the brakes. With it disconnected and depressing the brake lever the brake light didn’t illuminate. When i plug it back in the brake light is stuck on again. This sportsman has only 240 miles. The switch does NOT look easy to replace as there is alot of stuff surrounding it and im not sure if brake fluid would come out if i took it apart. Any help or walk throughs is appreciated. Also to add the only other issues is the rear left tire doesnt hold air long it will only hold about 1.5 PSI its a rawhide grip tire. Other thing is sometimes in AWD backing up or going forward for a few feet the atv pulls to one side as if its not disengaging 1 front tire (usually left tire).