Ok guys lets see what I messed up. I have a 1999 scrambler 500 it was running great but just idled too low and would die if it was just idling but ran great if you were in the throttle. I couldn’t increase the idle on the throttle cable on the handle bars because then it was too tight and would rev up when I would turn. I increase the idle via the idle screw on the carb maybe 1/2-3/4 turn and it idle great. Parked it for the night and went to get it out the next day and it doesn’t even attempt to start. The contacts in the ETC are good they aren’t touching and I returned the idle screw back to where it was and it still won’t start doesn’t even act like it’s trying to. The only other this is that that cable that is supposed to be on the carb with the thumb screw for the idle is missing so I was adjusting it via the little Nub with the spring. Right before the cable is supposed to attatch too and run to the other side of the carb. Any help would be great mad at myself for trying to fix one thing and causing it to not even start.