I could not find a thread showing the replacement of a CV shaft on the fourtrax that I obtained from my uncle that bought it brand-new. It had some clicking noises in the front end while turning the steering. Here are a few pictures as I put a new one in.

Tools needed:

Remove wheel:

Remove brake hub:

Remove cotter key:

Remove axle nut:

Remove cotter key, tie rod nut, tie rod

Remove brake line clamp bolts:

Remove bottom bolt from yoke:

Remove top bolt from yoke: (note threads showing above locking nut)

Pull assembly from cv shaft, use axle nut if need to hammer slightly on shaft to slide out of assembly:

Shaft should pull right out:

Replace with new or rebuilt cv shaft:

I did the pictures as I was putting it together but hope this sequence makes sense.

Good wrenching right there, these machines are really easy to work on. Good luck on your project.
———————————————
"Jesus paid for my sins- hope you can accept Him too"

Sent from my iPhone using Tapatalk