Long story short had my quad for about 3 years and not a issue. Took apart to clean up skins and clean everything because I sank it, cleaned carb. Took everything needed off and cleaned then put them back on . Went to start it and nothing (literally 1 day later) went through obvious checks. Pulled Spark plug and no spark. Pulled ignition coil and checked it out and seems ok, between signal pin and ground was 1.1 ohm, and signal pin to end of plug wore was 13k ohm. Checked signal wire and was getting around 36v. Decided what the he’ll and Tried again and started. All happy. Shut down had dinner and back out and no start :wtf:again checked coil and same. checked signal wire and only getting 12v but once plugged in to coil it goes 0v unplugged and back to 12v while cranking with nothing to the spark plug. And no spark… any ideas? I am new to quad mechanics but am 9 year experience in other type of mechanics
1985 polaris sportsman random no spark
Long story short had my quad for about 3 years and not a issue. Took apart to clean up skins and clean everything because I sank it, cleaned carb. Took everything needed off and cleaned then put them back on . Went to start it and nothing (literally 1 day later) went through obvious checks. Pulled Spark plug and no spark. Pulled ignition coil and checked it out and seems ok, between signal pin and ground was 1.1 ohm, and signal pin to end of plug wore was 13k ohm. Checked signal wire and was getting around 36v. Decided what the he’ll and Tried again and started. All happy. Shut down had dinner and back out and no start :wtf:again checked coil and same. checked signal wire and only getting 12v but once plugged in to coil it goes 0v unplugged and back to 12v while cranking with nothing to the spark plug. And no spark… any ideas? I am new to quad mechanics but am 9 year experience in other type of mechanics