I have a 1984 trx 200. It was not charging when I bought it. It starts and runs great. I cleaned all the connections. I checked the stator ac voltage and it was very low at only a few volts. I had the stator rewound and now it puts out 15v/AC at idle and goes up into the 40v/AC plus range when I rev the engine. Is that the correct voltage range? Still not charging the new battery. I checked the output at the regulator/rectifier. I used jumper wires so that I could access the harness the the regulator/rectifier. I have the stated AC voltage going in but only 1.4v/dc at idle and less than that when the engine is revved the engine. I replaced the regulator/rectifier and it is still the same. What could be going on? Could I have 2 bad regulator/rectifiers? Is the output of the stator too low?