So I finally installed my clutch kit from jbs today (sheave/16 gram weights/gold spring) I got the slug kit also but never installed that. Installation went smooth. My stock ratio was 2.5:1 roughly after the installation with a 1.1mm shim its a tad over 3.0:1
Now my tires are 28" zillas my stock top speed was 63 mph on a very long straight away would not go any higher and now I hit 61 on a lesser straight away before I ran out of room potential to staying the same 63 if given the same straight away distance which is weird after everything I read you loose top speed with shims so im happy with that. the grizzly definitely rev’s higher in all speeds. In low range the grizzly will wheelie without any rider input if the tires bite the ground just jab the throttle and its almost a gaurantee you got a wheelie it will even do wheelies while at a rolling slow speed. In high it will do it also without rider input but it has to be from a dead stop its more picky on the ground conditions and it either will or wont wheelie. With stock i would be able to wheelies but with rider input and a little obstacle helps out alot.. Im happy with the set-up not so happy that it costed $800, canadian dollar sucks but if i didnt pay i would always be wondering what 3.0:1 feels like with no top speed loss 🙂