This is a continuation of this thread:
http://www.grizzlycentral.com/forum/…all-rpm-s.html

I’m having some issues with my ’07 450 running right after cleaning the carb, and checking the valves. I think the carb is setup right and the issue lies elsewhere but would appreciate it if you guys could take a look at these photos and see if there are any obvious issues.

First thing I did was check the fuel level. I put a mark on the carb at 4.5mm. Put clear hose on the float drain and opened the screw. Fuel level looks good to me.

Attachment 31929

I opened the carb and checked to make sure the float looked level. I didn’t bother to measure with my calipers since the wet level was good. Visually, the float level looks good to me.

Attachment 31937

Here is an overall shot of the float bowl showing all jets.

Attachment 31945

Attached Thumbnails