Ok, well I have had this 4wheeler for about 3 months now and I love it. But I have a very serious problem that I absolutely cannot figure out, I took the carb off a few days ago to clean it and when I put it back on I started the four wheeler up and no gears would show on the selector. N, D, or R. So I looked around and noticed a broken wire on the sensor on the side of the carb. The greenish blue one to be exact. So I fixed the wire out it back together, and nothing. I tried to reset it, but it does nothing. So I kept messing with it, to the point where I disconnected just that wire from the plug and bam. Neutral shows up. And it runs fine, then the next day nothing again I pulled and put back the 30A engine fuse and it runs fine now in ESP but in auto it is like it’s staying in 1st gear. In fed up with it and I don’t want to drop 100s in sensors if it’s not the problem please reply…

Ok, well I have had this 4wheeler for about 3 months now and I love it. But I have a very serious problem that I absolutely cannot figure out, I took the carb off a few days ago to clean it and when I put it back on I started the four wheeler up and no gears would show on the selector. N, D, or R. So I looked around and noticed a broken wire on the sensor on the side of the carb. The greenish blue one to be exact. So I fixed the wire out it back together, and nothing. I tried to reset it, but it does nothing. So I kept messing with it, to the point where I disconnected just that wire from the plug and bam. Neutral shows up. And it runs fine, then the next day nothing again I pulled and put back the 30A engine fuse and it runs fine now in ESP but in auto it is like it’s staying in 1st gear. In fed up with it and I don’t want to drop 100s in sensors if it’s not the problem please reply…