Verified by putting it up on my quad stand. Sure enough, same thing happens. Pulled hub apart again (just serviced them) to clean and refilled with popo oil. On the lift it wants to engage and sometimes does at slow speed but when I feed in more throttle is disengages. Again, the driver side is fine. Yes it is getting power as I have watched the magnet engage the armature plate. Now i did find that the back side of the clutch cage is scored with deep uneven grooves like it wasn’t seating correctly. Below is a picture:
Since I have power I am assuming that the Hilliard clutch itself needs to be replaced. I did find a Billet cage on Amazon that uses the "guts" of the factory clutch. Fwiw I also noticed that the AWD light near the throttle does not light up. Perhaps a bad bulb? Thx for any help
