I am getting ready to run the wiring harness from the front bumper LED light I got last week to the battery/dash (on/off switch) and was thinking before I start is this split plastic tubing a good idea. I’m unsure if any of you wrap your harnesses inside this for any extra protection.

When I receive my LED roof mount in about a week, I will then run that wiring harness from the roof area to the battery. I see most use plastic ties to secure to the roll bar but unsure again, if any use this plastic tubing below that.

I am getting ready to run the wiring harness from the front bumper LED light I got last week to the battery/dash (on/off switch) and was thinking before I start is this split plastic tubing a good idea. I’m unsure if any of you wrap your harnesses inside this for any extra protection.

When I receive my LED roof mount in about a week, I will then run that wiring harness from the roof area to the battery. I see most use plastic ties to secure to the roll bar but unsure again, if any use this plastic tubing below that.