I’ve watched the PowerModz guy remove them on his XP900 and he had a pretty tough time as well but mine just wont seem to budge, I’ve sprayed and soaked them with PB Blaster and nothing. Can pry with every bar known to man but they don’t go anywhere.
Not only will they not budge but while pulling, the CV shaft came out of the inner knuckle. So the only hope that I could find was to pull the other side apart and hope it comes out so I could knock it out from the opposite side. Same thing happened over there, now I have two knuckles still in the trans and no good way to get them out. See here:
Imgur
I ordered a OTC CV puller slide hammer but I’m a bit skeptical it will actually be about to get in between the CV and the trans. They seem a lot like CVs on a car but they’re a bit different.
Any help would be awesome!