I am going to changing the cv boots on a 2006 Yamaha Wolverine 4×4 and was wondering if anyone had a way of getting the clamps on without the tool. Is there a tool you recommend? Is anyone a moose dealer on here? Any tips? Anything I should know as I have never tackled cv boots. I figure its good practice in case I have to do one on the rzr. Thanks in advance
I am going to changing the cv boots on a 2006 Yamaha Wolverine 4×4 and was wondering if anyone had a way of getting the clamps on without the tool. Is there a tool you recommend? Is anyone a moose dealer on here? Any tips? Anything I should know as I have never tackled cv boots. I figure its good practice in case I have to do one on the rzr. Thanks in advance
I have a detached garage/shop that I’ve been considering putting solar panels on so that I don’t have to pay a secondary hookup fee and run a second electric meter. Plus, it would be really nice to be able to power all of my tools and be able to run heat and AC in the shop without feeling the pain of another large electric bill.
Up until now, there wasn’t really a good solution for storing the energy from the solar panels if I wasn’t in the shop during the day or only had time to be in there on a dreary rainy day.
Solution? How about the new Tesla Powerwall system? Anyone look into this yet?
Does anyone have the proper tool for pressing in the mechanical seal on a 900 rzr xp water pump? I was hoping someone could measure how far in the inner seating surface should be compared to the outer. I just had a seal fail in two rides and I’m worried I am not installing the seal correctly.
Should the inner part of the seal be pushed further onto the shaft than it sits at rest to create a spring load in the seal? Or should it be installed at a relaxed state?
Looking for a jig fixture plate that is around 3′ x 3′ with holes every .5"-1" or so. Anybody know a good place to buy one? How about material and thickness of the plate?
Looking for a jig fixture plate that is around 3′ x 3′ with holes every .5"-1" or so. Anybody know a good place to buy one? How about material and thickness of the plate?