Category Archives: Lighting, Stereo and Electrical
Electrical Help/Design ?
I have had the car out twice since June and on our last trip we did some night driving and it doesn’t appear that the charging system can keep up with the draw and I end up below 12 volts, and I dare not turn on the stereo.
I have 13.5 and 14V until I start turning on lights and then drop to 12.5, 12 11.5 etc. with only the 30" rigid+10" rigid, A pillar and B pillar and dust lights (6 d series).
Description AMPS WATTS
30" Rigid RDS Light Bar 16.3 225
10" Rigid Hyper Combo 5.65 78
Heretic Studios Head Lamps ? ?
Rigid Dually Lights qty: 6 6.6 94.8
Rigid Rock Lights qty: 6 1.8 24
Lowrance Elite 7 M 0.9 12
Rugged Radio 686 2
Veretex 2000 Radio 20 50
Heated Seats 7 AMP Ea 28
Stereo System SSV 4 spkr 2 sub ?
Whip Lights ?
Am I crazy to think that these accessories can run of the stock charging system? I am planning on take it back to where I had the work done, but I really would like to gain a little knowledge before doing so.
Any advice, comments, questions, and direction would be genuinely appreciated.
OTRATTW / Contura Swich plate or LED removal?
Yes, I already tried contacting OTRATTW by both email and phone and no one answers / writes emails back.
Those with dual batteries what are you using to monitor voltage on second?
Fuel pump died
Anything common about this and is there an alternative to a Polaris pump?
Don.
Looking for some one knowlegable with trailer wiring.
I have a 7’x12′ trailer that I tow my RZR on. The wiring had gotten caught on something and was torn out.
I have just bought a new wiring harness and quality LED stop and turn signal lights. The new harness may have one wire less than the original that was torn out. I have got the turn signals and brake lights working but no running lights.
I am at a loss what to do next. Before I bought the LED lights and new harness, I took the trailer to a repair shop to have them repair the torn harness. I was told the trailer was repaired and I picked it up. I was in a hurry because I was leaving for several days. I did not check to see if the lights were working properly. I found out later that every thing was working except for the running lights.
With the new harness and LED lights that I have installed myself, everything works except the running lights. I do not want to take the trailer back to that shop.
The problem I am sure is something simple but my bird brain just cannot grasp what it is.
If anyone knows the answer please let know.
Thanks guys.