I guys new to this forum I need help my 2011 outlander 800 xxc will not charge the batterie I changed the stator the voltage regulator and the batterie and still showing LOW BATT VOLT as soon as I start the bike checked all grounds no corrosion on any of them after a while that it runs check engine light comes on and LMP home mode pops ups and idle increases I don’t know what else it could be if anyone had this problem would like some input thxs
Category Archives: Can-Am 2011 Models
rear diff concerns
I started on my 100hr service yesterday. I started with my diffs and gearbox. The oil that came out of the rear had so much fine metal in it, it looked like lapping compound. I’ve looked and searched and hadn’t seen any diff problems with G1. Is this a common issue?
800xxc wont turn over
i have an outlander 800xxc that has been sitting for a year. installed a new battery and it will not turn over. range selector says E and i have no headlights. anyone know where to start?
Hard Shifting and Squeal
On October 10, 2015, I purchased a 2011 Outlander 800r Max XT-P with 7500 kilometers. I drove it home, following my brother-in-law who also purchased an atv that day (2015 1000 Max Ltd). The drive took 1.5 Hrs. Items which I questioned:
1. I noticed mine was hard to put into gear unless I "humped it" (phrase picked up from reading some online posts).
2. I did not use it the following day but the very next day, I started it up and immediately it squealed at low RPM. That lasted for several minutes, then it would only squeal when I blipped the throttle (revved the engine). After a short drive it was back to it’s norm again. After reading several posts, I have ordered two new fully sealed oneway bearings along with the Isoflex NBU 15 grease.
3. I also popped the clutch cover and found that the belt constantly spins at idle. I am receptive to economical mods at the time I replace the bearings,, but I do not want to spend too much at this point until I’ve ridden it longer. It has standard sized tires Maxxis Mud 25 x 10 x 12 rear and 25 x 8 x 12 front.
4. Also, ck’g the air filter, it seems heavy, so I’m not sure how much it should weigh when new. If anyone has an idea pls let me know. Also, should I change it out,, I would like ideas on a dual filtration system.
1. I noticed mine was hard to put into gear unless I "humped it" (phrase picked up from reading some online posts).
2. I did not use it the following day but the very next day, I started it up and immediately it squealed at low RPM. That lasted for several minutes, then it would only squeal when I blipped the throttle (revved the engine). After a short drive it was back to it’s norm again. After reading several posts, I have ordered two new fully sealed oneway bearings along with the Isoflex NBU 15 grease.
3. I also popped the clutch cover and found that the belt constantly spins at idle. I am receptive to economical mods at the time I replace the bearings,, but I do not want to spend too much at this point until I’ve ridden it longer. It has standard sized tires Maxxis Mud 25 x 10 x 12 rear and 25 x 8 x 12 front.
4. Also, ck’g the air filter, it seems heavy, so I’m not sure how much it should weigh when new. If anyone has an idea pls let me know. Also, should I change it out,, I would like ideas on a dual filtration system.
Knocking sound
Hi. Im a new member from cold Norway.
I tried the norwegian forum but there is low activity.
Ok. I have knocking sound from the rear while turning in low speed. I thought it was the right driveshaft and changed both sides, but no luck! The knocking sound is still there only in low speed while turning.
Any ideas canam People?
Visco- lok QE in 2011s?
I’m getting a 2011 Outlander XT 800 w/ power steering, does it have the QE version of the visco-lok or the non -QE?
DPS replacement
Has anyone ever replaced the DPS unit themselves? Specifically on a 2011 Can-am Outlander Max XTP 800? Shop wants 3-4 hours of labor to do it but I have a friend who’s handy w/ mechanical stuff and thinks he can do it w/o too much problem. Seems a bit complex to me…what do you think? Thanks.
air filter, best place to order from?
Where is the best place to order a new stock filter for a 2011 Outlander 800R XT? (cheapest)
size for the iPhone series came with the iPhone 5
Squeak from somewhere
I have a 2011 max ltd, when I get the on the machine (or anyone does) it makes a rubbing or squeking sound that I can’t pinpoint. I’m thinking it is in the swing arm assembly – is it worth taking off the rubber cover to that to pack it with grease?