Asking $200
Thanks, Joe
Asking $200
Thanks, Joe
Sent from my iPhone using Tapatalk
I attached a audio of the sound
Thanks
I opened up the rear dif and it was good but when I opened the front dif oil started coming out (making me believe water was in there) so I’m just gunna change the front and rear dif oil just in case.
I hear people saying to use 75/90 in both front and rear and then I see 75/90 in the front and 75/140 in the rear. What should I use?
I purchased this for the radiator:
HEAT SENSOR SWITCH FOR BOMBARDIER CAN AM 709200089 709200003 715900095
I got a new engine sensor from eBay:
CAN AM OEM COOLANT TEMP SWITCH 05-08 OUTLANDER 420897938
I have two questions
1. Since I put the radiator sensor in, and drove the outy until the temperature switched the fan on, I turned off the engine and found that the fan would run for several minutes. I did test the new sensor and it would turn on around 200F. Is this normal for the fan to run so long..
2. The temperature warning light no longer comes on so i tested the engine temperature in boiling water to 220 F and it would not switch.
What temperature does the engine have to be to switch the sensor on and is it variable resistance or closed circuit?
2003 Polaris Sportsman 90 electrical is dead. 1st, a little background to what happened. The ATV was working fine, started up fine using the electric start and it took off and hit the hitch of a truck. Might have been a stuck open carb but I have not been able to replicate it since. Broke the fake light in the cowl.
Since then, there is no electrical at all.
No horn, tail light and no electric start.
It does however kickstart fine, usually 1st or 2nd try, but when running the horn and tail light still do not work at all.
I have bypassed all of the safety switches with jumper wires (wrist tether and brake switch)
I put a brand new battery in measuring 12.71 volts.
When the bike is running the red run/kill will turn it off. So will the key.
So, before I start dumping money into this thing, wondering if anyone can help me isolate probable cause and prioritize replacement components.
I am getting ready to sell it and want it in top working order prior to.
Any information or ideas would be greatly appreciated!!!
I am at wits end!
2003 Polaris Sportsman 90 electrical is dead. 1st, a little background to what happened. The ATV was working fine, started up fine using the electric start and it took off and hit the hitch of a truck. Might have been a stuck open carb but I have not been able to replicate it since. Broke the fake light in the cowl.
Since then, there is no electrical at all.
No horn, tail light and no electric start.
It does however kickstart fine, usually 1st or 2nd try, but when running the horn and tail light still do not work at all.
I have bypassed all of the safety switches with jumper wires (wrist tether and brake switch)
I put a brand new battery in measuring 12.71 volts.
When the bike is running the red run/kill will turn it off. So will the key.
So, before I start dumping money into this thing, wondering if anyone can help me isolate probable cause and prioritize replacement components.
I am getting ready to sell it and want it in top working order prior to.
Any information or ideas would be greatly appreciated!!!
I am at wits end!
Thermal Sensor Switch Fits Polaris Sportsman 500 2000 2004 500 RSE 2000 | eBay