Anyone have any problems from installing a 2" lift kit on their foreman? Thinking of installing one on my 07 foreman.

I have had nothing but issues withe the pump seals the little shaft is grooved and I suppose not making a good enough seal. question is can I leave counterbalance, gear, and waterpump intact and just bypass the waterpump with a external pump and if so does anyone no what type or how many gpm the external pump would need to pump

I have been having issues with the engine not idling right, or even staying running without giving it some throttle.

When I was replacing the head gasket, I noticed the throttle cable is for 2 carbs. The 350 is a single cylinder. I went to the dealer, and it shows that I have the right cable.

Why would there be a wye in the cable that goes nowhere?

My friend bought some 2" black anodized spacers on amazon. The seller he got them from no longer has them available. Does anyone know where I can find a set like that? I have searched and searched with no luck so far. All I can find are the shiny aluminum ones.

I was looking for a crf450 cam and I seen this on eBay . ProX 32.1402
Here are the specs
Duration @ 1.25 mm Lift – Intake:
242
Duration @ 1.25 mm Lift – Exhaust:
222
Lift – Exhaust:
5.00
Lift – Intake:
9.88
says it will give me low end gains . Can anyone tell from the specs of how it will be once on my trx450 it’s a 05 thanks

Hey I’m kinda new at this forum but I’ve got a 2010 850 xp touring and was riding yesterday and after 10-15 minutes of riding it started making a pretty loud whining noise coming from under the handlebars, it gets louder when you rev the engine, does it in gear and park and neutral, was trying to see where it was coming from and then it quit, just started doing this, can’t tell it’s affecting the running of it but it’s pretty loud, anybody had any problems or know what to look for, thought it might be water pump but not sure

Gord and I ride along with our friends at the Dufferin-Grey ATV Club in support of Ovarian cancer research. It was a rainy day on the trails outside Markdale Ontario but we still had a great ride!

For more info on the DGATV trails visit the club’s website: Welcome to the Dufferin Grey ATV Club I Markdale ATV Clubs

Filmed on GoPro Hero 4 Black
Bike-To-Bike Intercom: Scala Rider G9

Check out my YouTube channel for more ride vids: https://www.youtube.com/channel/UCi8…obSQLe6sDd1Qhw

I’m trying to change the pinion bearing on my 2006 outlander 800. Does anyone know the size of the spanner nut or where to buy the tool to remove it?. also do I need a special tool to remove the bearing too?

Thanks in advance

I’m trying to change the pinion bearing on my 2006 outlander 800. Does anyone know the size of the spanner nut or where to buy the tool to remove it?. also do I need a special tool to remove the bearing too?

Thanks in advance

ok so i went out to start my outlander to move it out of garage well i turned the key to on with the lights on right away i did not see my lights turn on or my fuel pump kick on, i also still tried to start n nothing the gear selector shows N on the screen then it turns to E n says transmission fault code . Its a 15 xmr 800 r outlander i removed the battery and cleaned the terminals and wire ends im giving the battery a quick hr charge on the table. What else would cause this ?